Hunter Rae Bad Baby x PopPlates | 3D Printed License Plate Frame

The Hunter Rae Bad Baby x PopPlates is a 3D printed sci-fi license plate frame designed and handcrafted in Vancouver, BC, Canada. Featuring oversized sculpted ears, dimensional forehead detailing, a lounging blue creature along the bottom, a three-fingered hand holding a bright blue snack, and raised BAD BABY lettering.

Available as a Single or Front & Back set. Fits standard North American license plates (12” × 6”).

──────────────────────

🎨 DESIGN INSPIRATION

Cute ears. Tiny chaos. Certified bad baby energy. This design started as a custom request from Instagram creator Hunter Rae (@ihunter_rae) through our PopPrompt program, and it got enough attention that we added it to the catalog. The soft mint-green palette and pink-lined ears establish the silhouette, the tan lower section gives it a warm desert feel, and then the details do the rest — a creature lounging along the bottom edge, a sculpted hand with a snack, and lettering that raises off the surface. It is the most dimensional frame we make.

──────────────────────

⚙️ FEATURES
• Originally a custom PopPrompt request, now a catalog design
• Oversized sculpted ears with pink interior detail
• Lounging blue creature along the lower edge
• Sculpted three-fingered hand holding a snack
• Raised BAD BABY lettering
• Our most complex multi-piece build — significantly more parts and print time

🛠️ CRAFTSMANSHIP
• Designed and 3D printed in Vancouver, BC 🇨🇦
• Made with durable, weather-resistant PLA filament
• Hand-assembled and finished by our small team
• From PopPlates — Star Seller on Etsy with a 4.8★ rating
• Built for everyday driving in all seasons

──────────────────────

❓ FREQUENTLY ASKED QUESTIONS

Why does this one cost more than other PopPlates?
It's the most complex frame we make. Oversized sculpted ears, dimensional forehead detail, a separate lounging creature, a three-fingered hand holding a snack, and raised BAD BABY lettering — many more individual printed and hand-assembled parts than a standard frame, and considerably more print time.

Where did the design come from?
It began as a custom request from Instagram creator Hunter Rae (@ihunter_rae) through our PopPrompt program. It got enough attention that we added it to the catalog.

Will it fit my car?
Yes, if your vehicle uses a standard 12” × 6” North American plate. This is our most dimensional frame — the ears extend well above the frame line. Measure both height and width around your plate before ordering.

Is this officially licensed?
This is an original fan-inspired design. PopPlates is not affiliated with or endorsed by Lucasfilm, Disney, or any franchise. Designed and made in Vancouver, BC.

How do I install it?
Slide the frame over your existing license plate and use your existing screws. No tools or modifications needed — about two minutes.

Can I go through a car wash?
Hand wash or touchless wash recommended. Mechanical brushes in automatic car washes can catch on the raised 3D elements.

──────────────────────

⚠️ Important Note: PopPlates are 3D-printed decorative frames designed for everyday driving conditions. They are not intended for use in automatic car washes. Please note that PopPlates designs are often larger than standard license plate frames — be sure to measure the area around your plate before purchasing to ensure proper fit.